Aigner

For mounting the spacer on the feeder unit

This block is for use where the Centrex is to be mounted on the back of the fence structure. Please check catalog for additional sizes

This piece of equipment is designed for spindle milling machines where it is necessary to provide an unobstructed table for machining curved work pieces. 335MM Optional: 500MM width available (additional cost)

These are required when mounting the Centrex and supporting bridge on a machine table when it may be necessary to fold the unit away.

For fastening the Centrex and the supporting bridge to the rear edge of the machine table.

For mounting the Centrex on the machine table when the size or strength of the fence housing prevents its attachment. 355 Inner width (optional 500mm)

For safe feeding of workpieces on circular saws, panel saws, narrow bandsaws and vertical spindle milling machines.

A device to allow short or thin pieces to be sawn using a work holder and side pressure.

To deflect short workpieces and cuttings from the circular saw blade.

For safe and precise positioning of machining cutters in cutter heads for spindle milling machines.

For use where a precise finish and pressure is needed when machining coated materials in timber and plastic material.

A further possibility for providing guidance and support.

Provides even more supportand pressure either side of the point of cut. Each wheel unit has lateral adjustability along the support rail for greater flexibility in positioning.

The universally usable pressure element for precise guidance; simple and fast insertion into the pressure module.

An important basic unit to provide a low friction side pressure on the work piece passing through (or top) the machine. Adjustment range between 5mm and 630mm with Allen key.