Aigner

Curved machining guide for 1-1/4" spindle for large Bowmouldmaster Options: 1-1/2", 30,35,40,50mm also available (additional cost)

To machine curved and circular workpieces economically, accurately and with maximum regard for safety. For tool diameters up to 150MM

Used on the table of the machine as a support for workpieces with more than one curve. For use with Small BowmouldMaster

Enables the pressure to be applied either side of the point of cut.

An important basic unit to provide a low friction side pressure on the work piece passing through (or top) the machine. Adjustment range between 5mm and 630mm with Allen key.

The universally usable pressure element for precise guidance; simple and fast insertion into the pressure module.

Provides even more supportand pressure either side of the point of cut. Each wheel unit has lateral adjustability along the support rail for greater flexibility in positioning.

A further possibility for providing guidance and support.

For use where a precise finish and pressure is needed when machining coated materials in timber and plastic material.

For safe and precise positioning of machining cutters in cutter heads for spindle milling machines.

To deflect short workpieces and cuttings from the circular saw blade.

A device to allow short or thin pieces to be sawn using a work holder and side pressure.

For safe feeding of workpieces on circular saws, panel saws, narrow bandsaws and vertical spindle milling machines.

For mounting the Centrex on the machine table when the size or strength of the fence housing prevents its attachment. 355 Inner width (optional 500mm)

For fastening the Centrex and the supporting bridge to the rear edge of the machine table.