Aigner

This block is for use where the Centrex is to be mounted on the back of the fence structure. Please check catalog for additional sizes

For use where a precise finish and pressure is needed when machining coated materials in timber and plastic material.

An improved work guidance and pressure system for passing work pieces across the face of a cutter head.

Provides even more supportand pressure either side of the point of cut. Each wheel unit has lateral adjustability along the support rail for greater flexibility in positioning.

A device to allow short or thin pieces to be sawn using a work holder and side pressure.

Handy help when sawing or milling circles.

These are required when mounting the Centrex and supporting bridge on a machine table when it may be necessary to fold the unit away.

An improved work guidance and pressure system for passing work pieces across the face of a cutter head.

The universal basic element on spindle milling machines with integrated sliding table for supporting safety and working units. Mounting rail V - II Right

The universal basic element on spindle milling machines with integrated sliding table for supporting safety and working units. Mounting rail V-I for left hand

A precise and rapid means of providing a profile across the end of a timber section.

For mounting the Centrex on the machine table when the size or strength of the fence housing prevents its attachment. 355 Inner width (optional 500mm)

This device enables glazing beads to be sawn from previously milled sections of window framing.

This device enables glazing beads to be sawn from previously milled sections of window framing.

Hinged auxiliary fence for surface planning machines.